Bradley 6322 Manual De Instalación

1. Provide a 1" diameter hole in basin at location where soap dispenser is desired.
2. Insert the shank through the hole in the basin and secure the shank with the neoprene washer,
steel washer, and wing nut provided (1).
NOTE: The shank can be cut to the correct length required.
3. Thread the adapter onto the shank . Then thread the soap container into the adapter.
4. On the plunger and valve assembly, place the square cut end of the supply tube on the cylinder
and tighten the tube on the cylinder with the cable tie provided (2).
NOTE: DO NOT install the angled cut end of the supply tube on the cylinder.
5. Insert the entire plunger and valve assembly with supply tube into the shank mounted to the
basin.
6. Tighten the escutcheon with the wrench provided (1).
Plunger and
Valve Assembly
Escutcheon
Neoprene
Steel
Washer
Washer
Wing
Shank
Nut
Adapter
Container
Steel
Washer
Installation
Wing
Nut
Soap
1
Escutcheon
Neoprene
Washer
Installation
Shank
6322, 6324, 6326
Adapter (for plastic
soap container only)
Soap Valves
Boutons-poussoirs de savon
Válvulas para jabón
Soap
Container
Plunger and
Valve Assembly
Cable
Tie
Cylinder
P.O. Box 309, Menomonee Falls, WI 53052-0309
PHONE: 800.BRADLEY (272.3539) bradleycorp.com
Made in Taiwan
Supply
Tube
P20-105 Rev. G; ECN 17-15-007
2
© 2017 Bradley
page 1 of 2
3/28/2017