Ⅱ Buttons; Silk Screen Of Buttons; Operating Instructions; On/Off - Airwell RCW8 Manual De Instrucciones

WIRED CONTROLLER RCW8
Buttons
Ⅱ

2.1 Silk Screen of Buttons

MODE BUTTON
TIMER ON BUTTON
TIMER ON I-FEEL
TIMER OFF BUTTON
TIMER OFF E-HEATER MODE
I-Feel BUTTON
ELECTRICAL
HEATER BUTTON RESET
RESET BUTTON
Fig. 3 Silk screen of buttons

Operating Instructions

III

3.1 On/Off

Press On/Off button to turn on the unit.
Press this button again to turn off the unit.

3.2 Mode Setting

When the unit is off, press the Mode button to switch through the operation modes in
the following sequence:
2
BUTTONS
ON / OFF BUTTON
ADJUST BUTTON ▲
SLEEP
ADJUST BUTTON ▼
TEMP
FAN SPEED SWING
SWING BUTTON
LOCK
SLEEP BUTTON
FAN SPEED BUTTON
LOCK BUTTON

3.3 Temperature Setting

Press or button to increase or decrease of set temperature when the unit is on.
Pressing either button continuously will increase or decrease the temperature by 1℃
every 0.5 seconds.
The temperature setting range is 17~30C
3

.4 Fan Speed Setting

By press the Fan button, fan speed of indoor unit will change as below:

3.5 Swing Control Function

Press SWING button to activate the supply aire flap to auto swing, if you push this
button again, the flap stops immediately.

3.6 Timer Setting

Timer on button :
Press this button, TIMER ON function is active. Then every press, the time will
increase 0.5h, after 10h, 1h increasing after each press.
.
To cancel this Function,just set it to "0.0"
Timer off button:
Press this button, TIMER OFF function is actived.Then every press, the time will
increase 0.5h, after 10h, 1h increasing after each press.
To cancel this function, just set it to "0.0" .
WIRED CONTROLLER RCW8
3
OPERATING INSTRUCTION