Airwell RCW8 Manual De Instrucciones página 6

WIRED CONTROLLER RCW8
Brief instructions:
1- Pull out the 5 core signal line from the mounting hole and pass this line through
the round hole located at the bottom of wired controller.
2- Use M4x20 scres to fix the foleplate of the wired controller on the wall.
3- Fix the signal line on the Tab A/B/C/D/E. Make sure the line is tightly fixed and
with no short circuit potential.(Fig. 5)
4- Put the panel and the bottom together.
5-way terminal
5-Core Shield wire
Fig.5
6
INSTALLATION
Emitter tube
+5V
GND
RUN
Indoor display board
Indoor Unit