Thermo Scientific Elite PCTS Manual Del Usuario página 3

pH Buffer Set Selection
Elite PCTS tester features USA (pH 4.01, pH 7.00 and pH 10.01) or NIST (pH 4.01, pH 6.86, and pH 9.18) stand-
ards. Select either one to suit your requirements.
1. Press to enter setup window. Press
Backlight.
2. Press to select Buffer. The display shows USA and NIST.
3. Press to select USA or scroll down by pressing
4. The display shows the selected buffer with a
Key Info
Scroll
Accept
EXIT
TDS Factor Setting
1. Press to enter setup window. Scroll down by pressing
2. Press to select settings. The display shows Buffer, TDS Factor and Backlight.
3. Scroll down by pressing
Factor.
4. Press to select the default TDS factory setting or
5. Press to confirm the selection of the setting. The display shows the selected temperature setting with a
Key Info
Scroll
Accept
EXIT
Backlight Settings
1. Press to enter setup window. Scroll down by pressing
2. Press to select Settings. The display shows Buffer, TDS factor and Backlight.
3. Scroll down by pressing
4. The display shows ON and OFF. Scroll down by pressing
increases readability in low light conditions.
5. Press to select the desired backlight option. The display shows the selected backlight option with a
Key Info
Scroll
Accept
EXIT
Elite PCTS Tester Operating Instructions
to select Settings. The display shows Buffer, TDS Factor and
Measure
Buffer
Settings
TDS Factor
Temp Set
Backlight
Reset
to toggle between the Buffer, TDS Factor and Backlight. Press
Measure
Buffer
Settings
TDS Factor
Temp Set
Backlight
Reset
to toggle between Buffer, TDS Factor and Backlight. Press
Measure
Buffer
Settings
TDS Factor
Temp Set
Backlight
Reset
to toggle between the two buffer standards.
.
USA
NIST
to select Settings.
to adjust the setting.
Adjust
TDS Factor
0.71
to select Settings.
to toggle between ON and OFF. Backlight ON
Backlight
ON
OFF
USA
0.66
to select Backlight.
OFF
to select the TDS
.
.
3