Brinkmann 7085 Manual Del Propietário página 7

7085-K_Gour Elec_Eng-SP.qxd
OPERATING INSTRUCTIONS
PLACE THE SMOKER OUTDOORS ON A HARD, LEVEL, NON-COMBUSTIBLE SURFACE
AWAY FROM ROOF OVERHANG OR ANY COMBUSTIBLE MATERIAL. NEVER USE ON WOODEN OR OTHER SURFACES THAT
COULD BURN. PLACE THE SMOKER AWAY FROM OPEN WINDOWS OR DOORS TO PREVENT SMOKE FROM ENTERING YOUR
HOUSE. IN WINDY WEATHER, PLACE THE SMOKER IN AN OUTDOOR AREA THAT IS PROTECTED FROM THE WIND.
Curing Your Smoker
1" (2.5 cm)
11/1/07 2:28 PM Page 8
READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY
BEFORE OPERATING YOUR SMOKER.
BRINKMANN
DALLAS, TX 75244
Prior to first use, cure your smoker to minimize damage to the exterior
finish as well as rid the smoker of paint odor that can impart unnatural
flavors to the first meal prepared. Cure your smoker periodically
throughout the year to protect against rust.
1. Remove water pan from smoker and leave out during curing process.
Lightly coat all interior surfaces of the smoker, dome lid and cooking
grill's with vegetable oil or vegetable oil spray. Do not coat lava rock
pan, lava rock or electric element.
NOTE: Do not use flavoring wood while curing your smoker.
2. With the dome lid on smoker, plug the smoker into electric outlet.
WARNING: Always use a 3-wire grounded outlet wired for 120-volts
which is GFCI protected at 15 or 20 amps. If in doubt, contact
a qualified electrician. Do not operate this smoker with any
other appliance or electrical device on the same circuit.
3. Cure smoker for three hours, then unplug smoker from electric outlet.
Allow smoker to cool completely. It is important that the exterior of the
smoker is not scraped or rubbed during the curing and cooling
process.
IMPORTANT: To protect your smoker from excessive rust, the unit must
be cured periodically and covered at all times when not in
use. A smoker cover may be ordered directly from
Brinkmann by calling 1-800-468-5252.
FOLLOW THESE STEPS BEFORE PLUGGING SMOKER INTO ELECTRIC OUTLET.
1. remove dome lid and smoker body from base pan.
2. Place flavoring wood on lava rock near the electric element. Refer to
"Flavoring Wood" section for recommended amount of flavoring wood
to use.
NOTE: Do not place the flavoring wood directly on the electric element.
This could cause flame flare-up and failure of the electric
element.
3. Place empty water pan inside smoker body on the lower support
brackets. Position water pan so rim is resting securely on notched out
step of all three support brackets.
6