Cleaning And Maintenance - EXALTA EL-310 Manual De Instrucciones

P RO FE SSIONAL HAIR CLIPP ER
GB
Do not use a damaged adapter and use only the adapter supplied.
If the adapter is damaged, always have it replaced with one of the original type in
order to avoid a hazard.
COMPONENTS OF HAIR CLIPPER
Charging indicator
ON/OFF switch
Blade adjustment ring (0,8-2mm)
Cutting guides 3/6/9/12mm
Moving cutting blade
Stainless steel blades
Oil
Brush
CHARGING
Before connecting the appliance to the mains, please check if the voltage of your
DC socket corresponds to the one stating in the rating label.
It is possible to charge the appliance connecting it directly with socket.
It is advisable to charge battery when it is totally discharged and not to charge the
appliance more than 48 hours; it will ensure a longer life to your product.
Once the charge has ended, disconnect the appliance from the socket.
After every usage, you can store the appliance on its support.
The charging light does not go out or change colour when the appliance is fully
charged.
To use the hair clipper connected to the mains: switch the hair clipper off, connect
it to the mains and wait a few seconds before switching it on.
CUTTING LENGHT ADJUSTMENT
The Hair Clipper is provided with 4 cutting guides, necessary to adjust the cutting
length from 0,8mm (without cutting guide) to 12 mm (with cutting guide).
WARNING:when you fit or remove the cutting guide, the appliance should always
be off.
Choose and attached the cutting guide according to the hair length you prefer
The cutting length is shown in the inner side of each cutting guide.
In order to put the preferred cutting guide, just attached it in the supports placed
in the two sides of blades (as shown in the picture here-below)

CLEANING AND MAINTENANCE

Before starting cleaning the appliance, always switch it off and unplug it.
Never immerse the appliance in water.
Clean the unit with a damp and soft cloth.
8