Sinbo SSC 6409 Manual Del Uso página 11

Lightweight
No heavy buckets to carry the shark steam mop weights only 3 lbs. Only one third the weight of carrying
a bucket of water and a mop.
Ergonomic soft grip handle
Comfortable design makes it easy to maneuver without physical strain.
Quick start-Up
Steam is ready in just 30 seconds.
Indicator light
Indicator light shows "red" when power switch is pushed "on" and water tank is not water.
Indicator light shows "green" when water tank is filled water.
Reusable cleaning pad
Durable triple layer micro-fiber cleaning pad loosens, lifts and looks in dirt, just toss in the washing
machine when done.
OPERATING INSTRUCTIONS
How to assemble your steam mop
Remove all the parts from the packaging.
Insert the extension tube into the handle. (Fig.1)
Insert the extension tube in connective pole. Make sure that the locking tab snaps into place. (Fig.2)
Place the micro-fiber cleaning pad underneath the mop head. Frap the rope with tight button. (Fig.3)
TIP: The micro-fiber cleaning pads have a colored tab so that a different pad can be assigned to different
tasks or rooms in the house.
Filling the water tank
IMPORTANT: Always insure that the unit is "UNPLUGGED" from the wall receptacle prior to initial filling
and before the bottom of the mop head .never use the steam mop without the micro-fiber cleaning pad
attached to the mop head.
Turn the cap counter clockwise and then lift up to remove from the water tank (Fig. 4)
Using the filling flask and funnel .pour one flask of water into the water tank .do not overfill the unit
passed the "MAX" fill line on the water tank. (Fig.4)
Replace the cap onto the water tank.
Using the steam mop
IMPORTANT: Never use the steam mop without the micro-fiber cleaning pad attached to the mop head
or without water in the water tank.
Warning: When water tank empty, the pump will little pumping noise and shake, Power switch must
turn off immediately.
1. Sweep or vacuum floors before using the steam mop.
2. Twist the quick release cord holder to unwrap the power cord completely.
3. Fill the water tank, the water line can't exceeded the "MAX" line.
4. Power switch is pushed "off". Plug into a 230-voit electrical outlet
Power switch is pushed "on". Indicator light is on (red or green).
5. Steam will wet micro-fiber. Its normal that pump will little noise and shake when beginning.
6. When the water tank is empty, indicator light is "red" and the pump will be turned off, no steam come
out.
Power switch must be turned off and unplug the power cord from the electrical outlet and refill the
water tank following the instructions above.
-10 -