Installing A Prewound Reel - Troy-Bilt TBSS Manual Del Operador

7. Repeat procedures 4-6 with the second piece of line.
8. Hold the outer spool. Wind the inner reel
counterclockwise until approximately four (4) inches (102
mm) of line remain (Fig. 12).
NOTE: Do not wind the inner reel before installing the second
piece of line.
9. If winding the line becomes difficult or the line jams, pull
the ends of the line from the spool (Fig. 13). Continue
winding the inner reel counterclockwise .

INSTALLING A PREWOUND REEL

1. Turn the bump knob counterclockwise and remove the
bump knob, spring, and foam seal (Fig. 14).
Bump Knob
Foam Seal
Spring
Inner Reel
8
MAINTENANCE AND REPAIR INSTRUCTIONS
Fig. 12
Fig. 13
Fig. 14
2. Pull the old inner reel with existing line from the outer
spool.
3. Insert the ends of the prewound inner reel line into the
outer spool eyelets (Fig. 15). Push the new inner reel,
arrow side up, into the outer spool.
4. Hold the inner reel in place and install the bump knob,
spring and foam seal. Press down and turn the bump knob
clockwise. Grasp the ends and pull
firmly to release the line from the holding slots in the inner
reel. (Fig. 13).
Releasing the Inner Reel
If the SpeedSpool ® does not release line correctly, pull the
ends of the line firmly from the spool (Fig. 13). If this does not
release line, follow the Cleaning the SpeedSpool
instructions.
CLEANING THE SPEEDSPOOL
Cleaning the SpeedSpool ® may be necessary,
• To remove jammed or excess line,
• If the SpeedSpool ® becomes difficult to wind or does not
operate correctly when bumping the head on the ground,
1. Hold the outer spool, and unscrew the bump knob
counterclockwise (Fig. 16).
Fig. 15
®
®
Fig. 16