Tabla de contenido
Publicidad
EN
AR BG CS DA DE ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SR SV TR UK
BATTERY CHARGER
SPECIFICATIONS
82V Charger: EBSRC82
Input: 230V
50/60Hz, 2.5A
Output: 82V
4A
CHARGING PROCEDURE
NOTE: The battery is not shipped fully
charged. It is recommended to fully charge
before use to ensure that maximum run time
can be achieved. This lithium-ion battery will
not develop a memory and may be charged
at any time.
1. Plug the charger into an AC power outlet.
2. Insert the battery pack (1) into the charger
(2).
1
2
This is a diagnostic charger. The Charger
LED Light will illuminate in specific order to
communicate the current battery status. They
are as follows:
LED STATUS
Blinking Green
Solid Green
Solid Red
Blinking Red
English (Original instructions)
DESCRIPTION
Charging
Fully Charged
Over Temperature
Charging Fault
False Defect Note:
When the battery is inserted into the charger,
and the status LED flashes, remove the
battery from the charger for 1 minute, then
reinsert. If the status LED indicates normal
than the battery pack is good. If the status LED
is still blinking, remove the battery pack and
unplug the charger. Wait 1 minute and plug
the charger back in and reinsert the battery
pack. If the status LED indicates normal than
the battery pack is good. If the status LED is
still blinking then the battery pack is defective
and needs to be replaced.
NOTE: When the red indictor flickers, pull out
the battery from the charger and insert again
within 2 hours. If the indictor shows charging,
that means the battery is good. After 2 hours,
please pull out the battery and also pull out
the AC power plug of the charger for 1 minute,
and then insert the AC power plug and the
battery again. If the indictor shows charging,
that means the battery is good. If not, the
battery needs to be changed.
CHECKING THE CHARGER
If the battery pack does not charge properly:
„ Check the current at the power outlet with
another tool. Make sure that the outlet is
not turned off.
„ Check that the charger contacts have not
been shorted by debris or foreign material.
„ If the surrounding air temperature is not
normal room temperature, move the
charger and battery pack to a location
where the temperature is between 6 ˚C
and 40˚C.
If the battery is inserted into the charger
when warm or hot, the CHARGING LED
indicator light on the charger may switch on
and illuminate RED. If this occurs allow the
battery to cool outside of the charger from
approximately 30 minutes.
4
WARNING
Publicidad
Tabla de contenido
