All-Pro SPC-54PHW Manual Del Propietário página 5

4. Insert manifold into pole support (see Figure 2).
Insert the manifold assembly through the post
by passing through the hole in the post support.
Note: Make sure hose and regulator assembly
attached to manifold are never bent or kinked
during installation and operation of heater.
5. Attach pole to pole support (Figure 3). Place
pole into pole support center connector.
Tighten six set screws with hex allen wrench
supplied with heater. Note: Set screws are
threaded inside post support.
6. Put propane/LP cylinder cover on base as-
sembly (see Figure 4). Slide propane/LP
cylinder cover over pole and pole support.
Be sure that propane/LP cylinder cover rests
level on the base.
Pole
Support
Figure 2 - Installing Manifold Assembly
114144-01D www.desatech.com 5