Safety Information; English - Hydor Koralia Serie Manual De Instrucciones

Koralia
6500/1650 - 8500/2250 - 10500/2750 - 12500/3250
Dear Hobbyist,
we thank You for choosing a KORALIA pump. Please read the following
instructions very carefully for best understanding of the characteristics of this
new, unique and innovative product.
Introduction
KoralIa is a new innovative range of circulation pumps for aquariums. The exclusive Hydor design and
technology guarantee a continuous and powerful water flow which can be directed freely thanks to the
special sphere shaped connection to the exclusive combination suction cup + magnet support. High
performance, low energy consumption, quick and easy maintenance. The combination suction cup +
magnet can safely hold KORALIA applied in tanks with glass (or acrylic) form 12 to 20 mm thick (from 0.5
to 0.8 in).
KoralIa are the new point of reference for quality and reliability thanks to the unique features:
Technical characteristics of the materials used for the components;
•
New auto-lubricating rotor technology without shaft;
•
Amazing low power absorption;
•
Quick and easy maintenance;
•
Exclusive electronic system to guarantee unidirectional start-up with AHS function.
•
What is AHS?
AHS - Anti-Heating System guarantees extra safety. This system automatically detects if the impellor is
blocked (this could happen in particularly hard working conditions) and after 3 start-up attempts cuts
the power supply to the pump preventing the motor from overheating dangerously (thus heating also the
aquarium) or damaging the internal circuits.
NOTE: should the AHS activate, to restart the pump, simply unplug it from the electrical supply, check the
cause of the impellor blocking, carryout maintenance as described in the appropriate paragraph and then
plug it back in.
description -fig.1-
Upper chamber
A.
Impeller
B.
Bearings + OR
C.
Lower chamber + Pump body
D.
Internal suction cup + magnet support (with rotation sphere)
E.
External suction cup + magnet support
F.
Cable protector
G.
attention!!!
Koralia pumps are specially designed for use in aquariums and tanks for water movement. It is not a
filtration pump. Please refer to your dealer for any other application.

safety information

attention: please verify that all components of the pump are undamaged before putting it into function.
Before any kind of intervention, ALWAYS disconnect electrical supply of the pump and any other appliance
placed in the water. Be sure that the voltage of the mains supply corresponds to the voltage shown on
the unit's label.
The pump is intended for indoor use only in fl uid with a temperature of max. 35° C (95° F).
•
DO NOT RUN DRY - Do not connect to electrical supply if pump is not completely immersed in water.
•
Do not connect to electrical supply if pump is missing parts.
•
Do not connect to electrical supply if pump is not positioned using the supplied suction-cup + magnet
•
support.
The cord of this pump cannot be replaced or repaired; in case of damage the entire unit must be substituted.
•
Do not cut or pull on the electrical cord.
•
Always disconnect from mains gently and make sure hands are dry.
•
When in function, make sure that the pump surface is not blocked.
•
When in function, make sure that the pump does not take in sand, as this could seriously damage the unit
•
and void the guarantee (read carefully the maintenance paragraph).
Due to the high attraction level between the magnets in the support, keep out of reach of children.
•
Avoid attaching the magnets directly to one-another.
•
Make sure you hold the magnets from the sides and avoid placing hands or fingers in between.
•
At a distance up to 5 cm (2 inches) the magnets attract metal objects and other magnets with a high force:
•
to prevent injuries, avoid closeness with blades, sharp objects or other magnets.
The magnet can cause permanent damage to electrical devices or articles that are affected by a magnetic
•
field such as pacemakers, credit cards, or keys: always maintain them at a minimum distance of 30 cm (12
inches).
When not in use, always place the carton separator between magnets.
•
If exposed to temperature higher than 50° C (122° F) the magnets can lose part or all the attracting power.
•
Always clean the aquarium side before placing the suctions cup + magnet support: any dirt on the surface
•
might prevent the suction cup from attaching properly and the pump might slip on the bottom of the
aquarium causing damage to things and itself.
Please keep these instruction in a safe and dry place.
•
Installation
attention: please verify that all components of the pump are undamaged before putting it into function.
Before any kind of intervention, ALWAYS disconnect electrical supply of the pump and any other appliance

English

7