Storage Recommendations; Battery Type; Package Contents - DeWalt DCV586M Traducido De Las Instrucciones Originales

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 47
Transporting the
Example of Use and Transport Label Marking
FLEXVOLT
Battery
TM
The D
WALT FLEXVOLT
TM
E
battery has two modes:
Use and Transport.
Use Mode: When the FLEXVOLT
a D
WALT 18V product, it will operate as an 18V battery. When
E
the FLEXVOLT
TM
battery is in a 54V or a 108V (two 54V batteries)
product, it will operate as a 54V battery.
Transport Mode: When the cap is attached to the FLEXVOLT
battery, the battery is in Transport mode. Keep the cap for
shipping.
When in Transport mode,
strings of cells are electrically
disconnected within the pack
resulting in 3 batteries with a
lower Watt hour (Wh) rating as compared to 1 battery with a
higher Watt hour rating. This increased quantity of 3 batteries
with the lower Watt hour rating can exempt the pack from
certain shipping regulations that are imposed upon the higher
Watt hour batteries.
For example, the Transport Wh rating might indicate 3 x 36 Wh,
meaning 3 batteries of 36 Wh each. The Use Wh rating might
indicate 108 Wh (1 battery implied).

Storage Recommendations

1. The best storage place is one that is cool and dry away
from direct sunlight and excess heat or cold. For optimum
battery performance and life, store battery packs at room
temperature when not in use.
2. For long storage, it is recommended to store a fully charged
battery pack in a cool, dry place out of the charger for
optimal results.
nOTE: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be recharged
before use.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual, the labels
on the charger and the battery pack may show the following
pictographs:
Read instruction manual before use.
See Technical Data for charging time.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Do not expose to water.
battery stands alone or is in
TM
TM
Have defective cords replaced immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care for
the environment.
Charge D
WALT battery packs only with designated
E
WALT chargers. Charging battery packs other
D
E
than the designated D
WALT charger may make them burst or lead to
D
E
other dangerous situations.
Do not incinerate the battery pack.
USE (without transport cap). Example: Wh rating
indicates 108 Wh (1 battery with 108 Wh).
TRANSPORT (with built-in transport cap). Example:
Wh rating indicates 3 x 36 Wh (3 batteries of 36 Wh).

Battery Type

The DCV586M operates on a 54 volt battery pack.
These battery packs may be used: DCB546, DCB547, DCB548.
Refer to Technical Data for more information.

Package Contents

The package contains:
1 Dust extractor
1 Remote (DCV585KV)
2 Filters
1 Hose
1 Fleece bag (kit only)
1 Li-Ion battery pack (C1, D1, L1, M1, P1, S1, T1, X1, Y1 models)
2 Li-Ion battery packs (C2, D2, L2, M2, P2, S2, T2, X2, Y2 models)
3 Li-Ion battery packs (C3, D3, L3, M3, P3, S3, T3, X3, Y3 models)
1 Instruction manual
nOTE: Battery packs, chargers and kitboxes are not included
with N models. Battery packs and chargers are not included with
NT models. B models include Bluetooth® battery packs.
nOTE: The Bluetooth® word mark and logos are registered
trademarks owned by the Bluetooth®, SIG, Inc. and any use of
such marks by D
WALT is under license. Other trademarks and
E
trade names are those of their respective owners.
Check for damage to the dust extractor, parts or accessories
which may have occurred during transport.
Take the time to thoroughly read and understand this manual
prior to operation.
EnGLIsh
WALT batteries with a
E
37

Publicidad

Tabla de contenido
loading

Tabla de contenido