MS Schippers 2505850 Modo De Empleo página 3

Bootcleaner model 09, extra stainless
steel
Boot cleaner, model 09, extra stainless steel
The boots are thoroughly and quickly cleaned by a combination of brushes, water and movement between the
brushes. After cleaning, fresh disinfectant (MS Oxy-DES , MS Megades or MS Macrodes) is added in the water
each time, in the right proportion. The result: hygienically clean boots. Together with the correct disinfectant or
detergent, the boot cleaner prevents the transfer of all types of pathogens. The boot cleaner is robust,
manufactured in stainless steel with hard wearing nylon brushes and sweep boot scraper for the underside of the
footwear. The boot cleaner is an extremely suitable means for company hygiene in various hygiene zones.
Dimensions, 90.0 X 26.0 X 54.5 cm
Connection
Connect the apparatus directly to a ½' water pipe.
Assembly
On a flat surface and close to a water outlet, as on a grate.
Ensure good and free access so that there are no obstructions to its use.
Work method
Open the supply tap. Ensure a stable position and move the boots between the brushes and over the sweep brush
so that the dirt is removed from the boots.
Chemical feed
Hang the loose pipe in a disinfectant (MS Oxy-DES, MS Megades of MS Macrodes) suitable for that purpose.
Open the water tap. By keeping your finger above the plastic hole the disinfectant is pumped up by the venturi
operation and mixed with the water.
Ensure that the pipe always hangs in the fluid and never on the ground, regarding contamination in the apparatus.
Preferably via an opening through the jerry–can cap so that the disinfectant can not become polluted.
Preferably choose a fast-acting, oxidising and cold stable disinfectant, such as MS Oxy-DES for a good result and
brushes that remain clean.
Replaceable parts
2504480 Lower brush for boot cleaner
2507833 Side brush for boot cleaner, above
2509164 Side brush for boot cleaner, below
2509597, Pipe set for boot cleaner extra hm
2509598, Tap for boot cleaner extra
Warning
In order to avoid low pressure in the water network we advise you not to connect the apparatus directly to the
water supply, otherwise there is the possibility that disinfectant may enter the water supply network.
With (night) frost ensure that the water is completely removed from the apparatus in order to avoid damage to
the apparatus.
Clean regularly under the apparatus in order to avoid the nipples becoming blocked.
VENTURI BUTTON
BOOT CLEANER
WATER TAP
WATER INLET
(LOW PRESSURE)
FLEXIBLE TUBE
DISINFECTANT
CONTAINER
3