Cable Connections - Conceptronic Grab'n'GO CHD3UES Guía De Iniciación Rápida

ENGLISH

3.2 Cable connections

a. Connect the power supply to the power outlet and to the hard disk.
b. Connect the USB cable to the USB port of the CHD3UES and to a free USB port on your
computer or connect the eSATA cable to the eSATA port of the CHD3UES and to a free eSATA
port on your computer (when your computer is equipped with an eSATA connection).
Note: When your computer is equipped with eSATA, it is advised to use this connection to
achieve higher data transfer speeds.
c. Use the power switch on the back of the CHD3UES to turn on the device. The Conceptronic
Logo on the front of the CHD3UES will light up blue.
Windows 2000, XP & Vista will automatically recognize the hard disk. No driver installation is
required to operate the CHD3UES.
4. Safely removing the Harddiskbox
The device must be deactivated before disconnecting the device otherwise data could be lost. You
can deactivate "USB Mass Storage Device" by double clicking the icon in the taskbar.
"Remove or eject hardware components" appears on the screen after double clicking. Activate the
appropriate USB component here and confirm with "Deactivate". A warning appears if you do not
deactivate the device before disconnecting.
Note: The "Safe Remove" option is not available when you use the eSATA connection. Make sure
there is no data written to the Harddisk when you disconnect the eSATA cable.
10