Conceptronic Grab'n'GO CHD3SU Guía De Iniciación Rápida página 7

ENGLISH
3. Hardware Installation CHD3SU
3.1 Assembling the CHD3SU (When no hard disk is installed yet)
If you bought the CHD3SU with a hard disk pre-installed, you can skip this step and
continue to step 3.2
Note: The CHD3SU can only be used with Serial ATA hard disks (SATA-I, SATA-II) !
a. Remove the 2 screws at the back of the CHD3SU and remove the back plate.
b. Gently slide the hard disk tray out of the housing.
c. Gently place the hard disk in the tray. The Serial ATA connector of the tray will
connect to the interface on the Harddisk.
7