Bosch LR Professional 1 Manual Original página 27

OBJ_BUCH-780-003.book Page 27 Tuesday, January 19, 2010 10:56 AM
English | 27
Audio Signal for Indication of the Laser Beam
The position of the laser beam on the reception area 6 can be indi-
cated via an audio signal.
After the measuring tool has been switched on, the audio signal is
always switched off.
When switching on the audio signal, you can choose between two
volume levels.
To switch on the audio signal or change the volume level, push the
acoustic signal button 3 until the requested volume level is indicat-
ed. At medium volume level, the audio signal indicator e in the dis-
play flashes; at high volume level, the indicator is continuously lit.
When the audio signal is set to off, the indicator goes out.
Working Advice
Marking
When the laser beam runs through the center of the reception area
6, its height can be marked at the centre mark 5 right and left on
the measuring tool. The centre mark is located 45 mm away from
the top edge of the measuring tool.
Aligning with the Spirit Level
The measuring tool can be aligned vertically (plumb line) with the
spirit level 8. A measuring tool applied out-of-level leads to faulty
measurements.
Bosch Power Tools 2 610 A12 917 | (19.1.10)