Cleaning And Maintenance; Cleaning The Brush - Melchioni Family FASTER Folleto De Instrucciones

The use of the suction lance is indicated for vacuuming deeply in the narrowest points such as skirting boards, folds of
sofas, armchairs, upholstered furniture, car seats.
To turn on the appliance, press the switch located under the handle.
The appliance will start operating at Standard power. Turbo power can be activated by pressing the button on the top of
the engine body .

CLEANING AND MAINTENANCE

We recommend cleaning the dust container after each use. Too much dust can cause blockage of the high efficiency
cotton filter, which must be cleaned or washed. If necessary, it can be replaced.
The roller brush must be cleaned after each use to ensure effective operation of the vacuum cleaner
EMPTYING AND CLEANING THE DUST COLLECTION CONTAINER
We recommend cleaning the dust container after each use. Too much dust can cause blockage of the high efficiency
cotton filter, which must be cleaned or washed. If necessary, it can be replaced.
The roller brush must be cleaned after each use to ensure effective operation of the vacuum cleaner.
1. Press the dust bin release button firmly to release the collected dirt
2. Turn the filter assembly counterclockwise and remove it
3. Rinse the filter unit under running water and gently shake it so as to eliminate any residual dirt and excess water; before
putting it back into the appliance, allow it to dry naturally away from at least heat sources
doorper 24 ore.
4. Reassemble the filter by reversing the operations done to remove it and close the
ATTENTION: Pressing the release button opens the lower base of the tank, therefore we recommend carrying out
this operation on top of a waste container.
ATTENTION: Make sure that all the components of the dust container are dry before reassembling them.
ATTENTION: During the cleaning procedure, check the condition of the filters. Replace the filters when visibly
damaged

CLEANING THE BRUSH

1) Remove the roller stop by pressing and pulling up on the tab located under the brush.
2) Remove the roller from the slot and clean it (not washable).