Accessories - Whirlpool WRS970CIDM Manual De Instrucciones Para El Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ICE AND WATER
Water is leaking or
dripping from the
dispenser
Water is leaking
from the back of the
refrigerator
Water from the
dispenser is
not cool enough
(on some models)

ACCESSORIES

The following accessories are available for your refrigerator.
To order an accessory: Contact us and ask for the part number listed,
or contact your authorized dealer.
In the U.S.A., call 1-800-442-9991 or visit
www.whirlpool.com/accessories.
In Canada, call 1-800-807-6777 or visit www.whirlpool.ca.
affresh
®
Stainless Steel Cleaner:
Order Part #W10355016
In Canada, order Part #W10355016B
®
affresh
Stainless Steel Wipes:
Order Part #W10355049
In Canada, order Part #W10355049B
affresh
®
Kitchen & Appliance Cleaner:
Order Part #W10355010
In Canada, order Part #W10355010B
Water Filter:
Order Part #W10295370A (P4RFWB)
Air Filter:
Order Part #W10311524
Produce Preserver:
Order Part #W10346771
24
24
Possible Causes and/or Recommended Solutions
NOTE: After dispensing, a few additional drops of water are normal.
Glass was not held under the dispenser long enough - Hold the glass under the dispenser for
2 to 3 seconds after releasing the dispenser pad/lever.
New installation, or water filter was recently installed or replaced - Air in the water lines causes the
water dispenser to drip. Flush the water system to remove the air in the water lines. See "Water and Ice
Dispensers."
Residual ice in the dispenser chute is melting - Make sure the ice chute is free of ice shavings or
pieces.
Water line connections are not fully tightened - Make sure all connections are firmly tightened. See
"Connect Water Supply."
NOTE: Water from the dispenser is chilled to 50°F (10°C).
New installation - Allow 24 hours after installation for the water supply to cool completely.
Recently dispensed a large amount of water - Allow 24 hours for the new water supply to cool
completely.
Water has not been recently dispensed - The first glass of water may not be cool. Discard the first
glass of water dispensed.
Refrigerator is not connected to a cold water pipe - Make sure the refrigerator is connected to a
cold water pipe. See "Water Supply Requirements."

Publicidad

Tabla de contenido
loading

Tabla de contenido