Belt Changing And Agitator Cleaning - Kenmore 116.35922 Manual Del Propietário

1. Remove Power-Mate _ cover as shown in
BELT CHANGING AND AGITATOR
CLEANING section
Push In
And Turn
2. Push in and turn
bulb counterclock-
wise, then pull out
to remove.
Push In
And Turn
3. Push in and turn
bulb clockwise, to
replace,, Bulb must
not be higher than
! 5 Watts(130 Volts),
4, Reinstall Power-Mate ® cover as shown in
BELT CHANGING AND AGITATOR
CLEANING section.
NOTE: See PARTS AND FEATURES for
bulb number,
=rlH,IIIIII'IH II ' II
,WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before per-
forming maintenance to the vacuum
cleaner. Failure to do so could result in
electrical shock or personal injury from
vacuum cleaner suddenly starting.
TO CHECKTHE BRUSHES
-_"__-- When brushes
___ are worn to the
level of the base
support bars,
replace the
agitator
Base Support Bars
assembly.
TO REPLACE AGITATOR
ASSEMBLY
1. Remove Power-Mate ®cover, belt and
agitator assembly. See "To Remove Belt" in
BELT CHANGING AND AGITATOR
CLEANING
2. Replace agitator assembly,
3, Reinstall belt and Power-Mate@ cover.
See "To replace belt" in BELT CHANGING
AND AGITATOR CLEANING,
20