Belt Changing And Agitator Cleaning; Agitator Assembly - Kenmore 116.22812 Manual Del Propietário

!
._ WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result in elec-
trical shock or personal injury from
cleaner suddenly starting.
!1 ii1'!11111 i'"
TO CHECK AGITATOR
ASSEMBLY
-_=:_-----___ When brushes
_)}_ __._ are worn to the
level of the base
support bars,
replace the
agitator
assembly_
Base Support Bars
TO REPLACE AGITATOR
ASSEMBLY
1. Remove Power-Mate ® cover, agitator
cover, belt and agitator assembly. See
"To Remove Belt" in BELT CHANGING
AND AGITATOR CLEANING°
2, Remove end caps, washers, screws,
end brush, and brush sprocket pieces
from ends of old agitator assembty
3. Reassemble agitator assembly. To Iine ...........
up screw holes in dowel, sprocket and ,_._._._;_-_
end brush, be sure all of the brush _{_:;;
sprocket pieces align properly, See ::_:;_t,_:
AGITATOR ASSEMBLY. .............
4. Reinstall belt, agitator assembly,
agitator cover and Power-Mate e cover°
See "To Replace Beft" in BELT
CHANGING AND AGITATOR CLEANING.
End
Cap
Washer
End
Brush End
Screw Cap
Agitator Unit Washer
Brush Sprocket
19