Cardin Elettronica S508 Manual De Instrucciones página 21

SETTING THE CHANNEL MODULE MODE
All the receiver channels can be set independently using the following parameters:
Activation mode:
Power On Reset:
Inactive state:
The default state is impulsive mode, power on reset enabled and normally open contact when
the channel is at rest.
• To set the channel module mode:
- press and hold down the
- the symbol
been activated;
- to quit (after twenty seconds of inactivity the procedure will terminate automatically), press
DEL
the key and the receiver will restart.
- using the
- press to modify the parameters or
MEMO
- the current channel settings will be shown on the display with each digit representing a dif-
ferent parameter as follows:
establishes the activation mode for the channel which can be impulsive,
time controlled or bistable (ON/OFF)
establishes if the channel will be forced into the inactive condition when
the receiver is reset
establishes the type of contact for the inactive (at rest) state of the chan-
nel selecting between normally open (NO) or normally closed (NC)
keys simultaneously for at least four seconds;
will appear on the display indicating that the channel setting menu has
keys, select the channel you wish to set from
to quit the procedure;
DEL
21
, , , ;