Safety And Installation Instructions - Dometic WAECO MagicWatch MWE910 Instrucciones De Montaje Y De Uso

Safety and installation instructions

1 Safety and installation instructions
The following texts only complete the figures on the supplementary
sheet. They do not contain the full installation and operating instruc-
tions. Please observe the figures on the supplementary sheet.
Please observe the prescribed safety instructions and stipulations
from the vehicle manufacturer and service workshops.
Observe the applicable legal regulations.
The manufacturer accepts no liability for damage in the following cases:
 Damage to the product resulting from mechanical influences and excess
voltage
 Alterations to the product without express permission from the manu-
facturer
 Use for purposes other than those described in the operating manual
CAUTION!
!
 Secure the parts of the parking aid installed in the vehicle in
such a way that they cannot become loose under any circum-
stances (sudden braking, accidents) and cause injuries to the
occupants of the vehicle.
 Do not fit the parts of the parking aid installed where an airbag
may open. This could cause injury if the airbag opens.
 The parking aid is intended as an additional aid, which means it
does not relieve you of the obligation to take due care when
manoeuvring.
NOTICE!
A
 Installing the parking aid can cause problems on vehicles with
LED tail lights.
 If you would like to install the sensors on metal bumpers, you
require suitable adapters (not included in the scope of delivery).
 Do not expose the control electronics to dampness.
 The sensors may not cover signal lamps.
 When fitting the sensors, make sure there are no objects fixed
to the vehicle that are in the detection range of the sensors.
 Apply a small amount of grease inside the sensor plug connec-
tions.
20
All manuals and user guides at all-guides.com
MagicWatch MWE910, 900, 900F
EN