Rowenta BALNEA SILENCE SO6210 Manual Del Usuario página 8

Wall Attachment: see fig. 4a.
• Attach the wall bracket with appropriate screws and plugs following the direction of the arrow.
• Insert the upper wall-bracket hook in the unit's transport handle, and clip the lower wall-bracket
hook onto the unit.
Taking Down the Unit: see fig. 4b.
• Maintain a solid grip on the unit and push down upon the lower tongue of the wall bracket.
• Pull the unit out from the bottom.
• Lift the unit up and remove it from the upper hook.
SAFETY
In the event of abnormal overheating, a safety device shuts down the appliance and then automati-
cally restarts it once ithas cooled. If the fault persists or gets worse, a thermal fuse shuts the ap-
pliance down definitively and it must then be taken to an approved service centre.
OPERATION
Each time before use, check that the appliance is in good condition.
Especially check that:
- the position of the appliance described in these instructions is respected.
- the air inlet and outlet grids are in no way obstructed.
- the appliance is placed on a horizontal, stable surface.
MODEL SO6210 :
Button 1 : Operating mode selector:
: OFF Position
: Cold ventilation position
: "Silence" position, 1200W ventilated and regulated
: 2400W position, ventilated and regulated
Indicator light 2 : The indicator light is lit when the ap-
pliance is operated with the knob 1.
Button 3 : Thermostat (knob 1 must be in the
- Adjust the temperature setting, according to your own comfort.
- Frost-free setting
0°C in a normally insulated room, whose volume corresponds to the power of your appliance.
MODEL SO6220 :
When switching on the power to the appliance (appliance plugged into the mains), the appliance is
in the "STOP" mode, and the knob 1 is lit.
The appliance makes a beep every time the control knobs are moved.
: This setting enables you to automatically maintain the temperature above
• ••
or position).
8
2
1
GB
3