Ega Master EGATronik 51264 Manual De Instrucciones página 15

Function
- In the function of measuring wind velocity this button will change the units:
- In function of the measurement of wind flow this button will change → CFM
- In the function of the measurement of the speed of the wind we change the
- In function of the measurement of wind flow we change the values: maximum,
Press once to enter the Hold mode. Press it again to exit Hold mode. Continually
- This button will select the measurement function of speed or wind flow.
- In case of many data stored within the data reading option, the button will pass
This button will change the temperature units between °F / °C. Within the option of
Press to activate the REC. Press and hold this button to access the reading of
It is the button that leads to the menu of the meter. Pressing and holding it down
Press this button to enter a point (stop insert decimals) the option of introduction of
Power on / Power off Button
m / s → ft / min → KNOTS → Km / h → MPH and vice versa
CMM units and vice versa
Button 2: MAX/MIN/media
values: maximum, minimum, and instant.
minimum, 2/3V of maximum, average and instantaneous.
press to open backlight display.
Button 4: VEL/FLOW/+100
the values of 100 to 100.
Button 5: D.LOAD
Button to move the data to a PC via the USB cable.
Button 6: °F/°C/Rec 1
reading data, this button will take you to the first stored value.
Button 7: REC/READ
values of the database.
Button 8: CLEAR
Press to erase recorded data the database.
can change the settings of the meter.
START/NEXT: lower left button
the measure of the area.
Button 0: SAMPLE/AREA
Button for settings of the area measurement
ENTER: lower right button
Button to confirm the key. See user configuration
Description
Button 1: UNIT 1
Button 3: HOLD
Button 9: MENU
15