EFI ES-2000 Guia De Instalacion página 4

When prompted to place the EFI ES-2000 in the calibration cradle, make sure that the white
tile cover on the cradle is open (the slider is drawn back) and that the EFI ES-2000 aperture is
in full contact with the white tile. If you do not place the EFI ES-2000 correctly in the
calibration cradle, it does not return accurate measurements. For best results, keep the white
tile properly cleaned, as described in
You must use the calibration cradle that was packaged with your EFI ES-2000.
N :
OTE
The calibration cradle has the same serial number as your EFI ES-2000.
EFI ES-2000 instrument settings in Color Profiler Suite
When you use the EFI ES-2000 with Color Profiler Suite, you can set the instrument settings:
•
Measurement mode:
in Strip measurement).
• If this option is selected, the positioning sensor on the underside of the
Use ruler:
EFI ES-2000 reads the stripes on the ruler to determine the position of the EFI ES-2000
when you measure a strip. The use of the ruler is required for strip measurement in two
passes (described in
•
Large patch size:
measurements with a low-resolution printer. The measurement method is the same for
regular and for large patches.
Single-patch measurement
Use the patch guide to measure a single patch.
T
O MEASURE A SINGLE PATCH
1 Attach the EFI ES-2000 to the patch guide by inserting the connector on the patch guide into
the rear slot of the EFI ES-2000.
The EFI ES-2000 aperture fits in the round hole of the patch guide.
2 Position the aperture of the EFI ES-2000 in the middle of the patch that you want to
measure.
3 Press and release the button on the side of the EFI ES-2000.
The status lights on the EFI ES-2000 are off when the measurement has been recorded.
"Maintenance and cleaning" on page
When you measure a strip, select the type of measurement (described
Strip measurement).
If this option is selected, larger patches are printed to allow for better
4
6.