Configuration
ENGLISH
The interface module can be used to:
• Configure all modules connected to IPerBus.
• Connect to the IPerHome PRO 1071/4 server.
The modules are configured via a laptop PC
equipped with IPerSet software connected to the
1071/56 by means of a USB cable. The USB cable
must be plugged into the USB port under the remov-
able flap. Configuration is therefore possible with the
electric panel closed, e.g. in the case of cases and/
updates following system commissioning.
Connection to the IPerHome PRO server, instead, is
via a serial cable (provide with the 1071/4 server)
the coloured wires of wire are connected to the ter-
minal board.
The two situations are shown in the following fig-
ures.
DS1071-004
5