LUND 66903 Manual Del Usuario página 14

GB
to use the product with a damaged power cord. Repairing the power
cord is forbidden. It must be replaced with a new one at an autho-
rised service centre. Use only with the attached power supply unit.
Using other power supply units is not allowed. The product must be
kept under supervision at all times during operation. Do not leave the
device unattended if it is connected to the power supply. The device
is not to be used by children. Keep the device and its power cord
out of the reach of children. It is important to ensure that children do
not see the device as a toy. Children should not be allowed to clean
or perform maintenance activities on the device without supervision.
This device cannot be used by people with impaired physical and/or
mental abilities, or by people without experience in or understanding
of the operation of the device, unless they are supervised or instruc-
ted on how to safely operate the device so that they understand the
relevant operating risks. The water tank cannot be opened during
use. Do not use the device if it has been dropped, if there are visible
signs of damage, or if it is leaking. It is important to be aware that high
humidity levels can promote the growth of biological organisms in the
surroundings. Do not allow the area around the humidifi er to become
wet or damp. If moisture is discovered, turn off the humidifi er. Use the
humidifi er in intervals if it cannot be switched off . Moisture-absorbing
materials such as carpets, curtains, drapes or tablecloths should not
be allowed to become damp. Do not leave water in the tank when
the device is not operating. Empty and clean the humidifi er before
storage. Clean the humidifi er before next use.
USING THE DEVICE
Preparing the device for use
Unpack the device and remove all packaging components. It is recommended to keep the packaging for
later storage. Clean the water tank, the lid, and housing according to the instructions found in the "Device
maintenance" section.
Put the power cord plug into the socket on the base of the device (II). Do not connect the plug at the other end
of the cord to the power supply yet. Set the device in the location where it will be used. Remove / open the
device's lid (III). Fill the device's tank with water or a mixture of water and fragrance. Reattach / close the lid so
14
O R I G I N A L I N S T R U C T I O N S