Tabla de contenido
Publicidad
IP Rating
Storage Capacity:
Resolution:
Dimensions:
Display:
Alarms:
Battery/Life:
Download:
Minimum Version
Dicksonware™ Required:
Getting Started
•
Install the DicksonWare™ Software.
•
Connect the cable (supplied with the software) to the logger and to a working serial or USB port on
your computer.
•
Click the Setup button. When the setup window appears, all fields should be automatically filled
•
in, this will confirm that DicksonWare has recognized the logger. Should all fields remain blank, refer to
•
"No Communication" in the Trouble Shooting section of this manual. Once DicksonWare™ recognizes
the logger, press the Clear button. This will delete all data currently stored.
•
The logger is now sampling and ready for use, a Delta (∆) symbol will appear in the display to confirm
logging. The default sample interval is 1 minute. You may choose to change Default settings for
sample interval and start-date and time. When changing these settings, the logger will automatically
go through the clear process to accept your changes.
•
Please refer to the "Software and Logger Operations" section of this manual for more Setup and
Download instructions.
•
Networking: While the unit is connected via Serial or USB, enter a valid IP address for the unit in the
Network tab in the Setup window. See the Network Setup section for more information.
•
Note: To achieve longer battery life during operation, use a less frequent sample rate, disconnecting
the unit form the USB port when not downloading data, limiting the frequency of memory card
transfers, and NOT inserting the memory card unless downloading.
Operating Instructions
Alarm
•
Pressing this button will silence the alarm. Holding this button down for about 5 seconds will toggle
between Fahrenheit and Celsius. (Alarm parameters can only be set in DicksonWare™.)
MIN/MAX
•
Pressing this button will start the Min/Max display cycle.
Clearing MIN/MAX Values
•
Holding the "MIN/MAX" and "ALARM" buttons down together until "clr" appears on display will
clear the stored minimum and maximum values. The Min and Max displayed by the logger will be the
minimum and maximum values sensed since it was last cleared.
•
Note: DicksonWare™ will show the minimum and maximum values of the downloaded data. These
could be different than that displayed on the unit itself. For
•
Example: Your logger is set for a 2 minute sample which is good for about 11 days. After 5 days
you clear MIN/MAX. After another 6 days you download the logger. The Min/Max displayed by the
logger will be the MIN/MAX for the last 6 days. The MIN/MAX shown by DicksonWare™ will be the
Min/Max for the last entire 11 days. Dew point MIN/MAX in the TM320 and TM325 models are not
updated unless dew point is enabled. (See Software Setup Instructions)
Rev. 01/09
Common Product Specifications
IP20
32,000 sample points (div. x 2)
0.1°F
4.0" x 3.0" x 1.6" (10.2cm x 7.7cm x 3.9cm)
LCD 4 Digit
High/Low Audible Alarm
One 9V battery; 3 hours
Ethernet Connectivity or USB, Serial
DicksonWare™ SECURE version 9.0
Continued on next page
Publicidad
Tabla de contenido
