Mr Coffee BVMC-ECMP55 Manual De Instrucciones página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

YOUR ESPRESSO/CAPPUCCINO
MAKER MAY BE DELIMED USING
WHITE HOUSEHOLD VINEGAR AS
FOLLOWS:
TO DESCALE WATER RESERVOIR:
1. Make sure the control knob is in the OFF position, the
ON/OFF switch is in the OFF position and that the power
cord is disconnected from the electrical outlet.
2. Fill the reservoir with fresh, undiluted white household
vinegar.
3. Allow appliance to sit overnight with the vinegar
solution in the water reservoir.
4. Discard vinegar by removing the reservoir and turning it
upside down over the sink.
5. Rinse the water reservoir thoroughly with tap water
by filling tank half full with water and then pouring the
water back out into the sink, repeating this step twice.
TO DESCALE INTERNAL PARTS:
1. Make sure you delime the inside of the water reservoir
first by following the "Deliming" steps above.
2. Make sure all controls are in the OFF position and the
power cord is disconnected from the electrical outlet.
(See Section "CAUTION" on Pages E3 and E7). Fill the
reservoir with white vinegar above the minimum level
into reservoir.
3. Insert the brew basket (with filter) and place jar/carafe
or regular cup on top of the drip tray and under the
brew basket.
4. Plug the power cord into the electrical outlet.
5. Turn the ON/OFF Switch to the ON position. Press the
BVMC-ECMP55_13ESM1.indd 19-20
E17
Brew / Steam switch to the BREW "
Brew/Steam Indicator Light is ON, turn the Control Knob
to the BREW "
" position. The vinegar will start flowing
through the unit. Once all the vinegar has been drained
from the reservoir turn the control knob clockwise to
the OFF position.
6. To remove any remaning traces of vinegar from the
internal parts, repeat steps 2-5 above, replacing the
vinegar with water, as often necessary.
7. To clean the frothing tube internally, place a cup with
cold water under the tip of the frothing tube. Turn the
Brew/Steam Switch to STEAM "
the Brew/Steam Indicator Light becomes green. Insert
the frothing tube into the water, turn the control knob
to the STEAM "
" position. Let the steam come out
for about 10 seconds. This will clean any residue left in
the frothing tube from frothing milk.
8. Turn the control knob counter-clockwise to the OFF
position and press the ON/OFF switch to the OFF
position.
9. Repeat Steps 1 – 8 as necessary using only tap water
to rinse any remaining traces of vinegar out of the
machine.
" position, after
" position, wait until
E18
2/22/13 2:26 PM

Publicidad

Tabla de contenido
loading

Tabla de contenido