Disposal And Recycling - Matrix PG 5600-1 Traducción Del Manual Original

- Only use motor oil (15W40/<0
- Place the generator on a slightly inclined surface
so that the oil drain plug is at the lower end.
- Open the oil filler plug (9).
- Open the oil drain plug (10) and let the hot
engine oil drain out into a drip tray.
- After the old oil has drained out, close the oil
drain plug and place the generator on a level
surface again.
- Fill in engine oil up to the top mark on the oil
dip stick.
- Important: Do not screw the dipstick in to check
the oil level, simply insert it up to the thread.
- Dispose of the waste oil properly.
8.5 Oil shortage cut-out
The oil shortage cut-out (11)
is too little oil in the engine. In this case it will
not be possible to start the engine or it will cut
out automatically after a short period of time. It
cannot be started again until the engine oil has
been topped up (see point 8.4).

9. Disposal and recycling

The unit is supplied in packaging to prevent its
being damaged in transit. This packaging is raw
material and can therefore be reused or can be
returned to the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of
as special waste. Ask your dealer or your local
council.
10. Transport
These requirements must be met:
• Generator is turned off
• Generator is cooled down
• Petrol cock (16) is at "OFF" position
• At least one person per transportation handle
(21)
o
C: 5W30).
responds if there
72
ATTENTION! Slipping or falling unit can
crush hands and feet.
Carry the generator on transportation handles:
• Lift the generator evenly
• Carry the generator to the operating place
• Drop the generator evenly
Carry the generator with wheel (17) and carry
handle (18):
• Assemble wheels and carry handle (see chapter
6.1 and 6.3)
• The generator can be carried by lifting the carry
handle (18)