Guardian G1-400BX2 Manual De Instrucciones Para El Usuario Y Garantía página 3

parts described here. Check all parts for damage before
use. If any parts are missing or damaged, DO NOT
attempt to use the commode.
Important If you do not understand the manual, contact
your dealer for a complete explanation of the instructions,
cautions and warnings. Otherwise, injury may result.
2. If exposed to cold temperatures, allow contents to come
to room temperature before assembly. This helps avoid
damaging the clamps during assembly.
3. Align the clamps on the toilet seat platform so they rest
on the front and back frame rails. (Figure 1)
Push down on seat platform with both hands until all
four clamps snap firmly into place.
4. From the front of the frame, slide the bucket (without lid)
under the seat until you feel it "click" into place.
5. The commode is now ready for use.
Adjust Commode Height
1. Before using the seat, make
sure all legs are set to the same
preferred height.
2. To do so, depress pushbutton
and slide each leg to desired
height by aligning with proper
holes and letting the pushbutton
snap into the correct hole to lock
leg in place. (Figure 2)
3. Make sure legs are locked into place by pushing down
and pulling up on each leg.
Using as Bedside Commode
1. Set commode to desired height, making sure each leg is
locked into place.
2. Be sure the commode pail is snapped into pail support
bracket and properly positioned below commode
opening.
3. When user is finished using commode, place pail lid
over commode pail to contain odors.
4. Clean seat and pail with disinfectant after each use.
Figure 2
G1-400BX2 (PIC-00244)
REVISED: 04/09/20