Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
KH2020F / KH2030F / KH2520F
1) Check the oil level that must be always higher than the rod notch (A).
3) If the electric current characteristics (Volt/Hz) correspond to those
stated on the label fixed to the machine, you can insert the plug. The
use of extensions and loose plugs not to standards is prohibited. The
electrical system the machine is connected to must be made in
conformity with the laws in force in the Country of installation. It is
recommended to have a differential thermomagnetic switch with
sensitivity equal to 30 m A upstream from the power socket.
INSTALLATION
4) Connect the water supply hose (the
inner diameter must be not smaller than 14
mm) to the pump inlet fitting (D). Make
sure that the suction filter of the suction
fitting is always clean. The dirty filter
causes
consequently a very bad pump operation
with the inevitable risk of a rapid wearing
out
and
mechanisms.
24
2) Connect the high pressure
hose to the outlet fitting (B),
tightening the ferrule completely
and
the
other
automatic gun (C).
a
bad
water
breakage
of
end
to
the
supply
and
the
internal
Publicidad
Capítulos
Tabla de contenido
