If The Sound Is Distorted; If You Hear A "Hum" Sound In The Recording; If Your Recordings Are Only In The Left Channel; If Your Computer Doesn't See Your Tunestudio - Belkin TuneStudio Manual Del Usuario

if the sound is distorted:

if the left or right +6 dB recording level LEd lights up:
• Turn down the volume on your instrument.
• Turn down the channel's level control.
• T urn down the master recording level control.

if you hear a "hum" sound in the recording:

• If you're using a condenser microphone, try turning on phantom power and increase the level control.
• If you're recording an instrument, turn up the instrument's volume control.
• Try connecting your instrument, TuneStudio, and computer to a grounded power strip.

if your recordings are only in the left channel:

• Make sure your iPod is configured to record in "High Quality" mode. On your iPod, select "Extras > Voice
Memos" and set Quality to "High". Your TuneStudio will not work correctly with Quality set to "Low".
• Check your cable connections.
• Make sure that your pan and balance controls are not set all the way to the left.

if your computer doesn't see your tuneStudio:

• Make sure the USB cable is securely connected.
• Unplug the USB cable and turn off your TuneStudio. Then, turn your TuneStudio on and reconnect the USB
cable. If this doesn't work, leave your TuneStudio on and restart your computer.
• Make sure the TuneStudio is selected as an audio output device. See page 18.
tRouBLESHootiNG
24