Changing The Light Bulb - ROSIERES Candy RBLP230 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 61
Force Center.
Symptom
Appliance does not work.
Appliance cools too much.
The food is too warm.
Interior lighting does not
work.
Heavy build-up of frost,
possibly also on the door
seal.
Unusual noises.
The compressor does not
start immediately after
changing the temperature
setting.
Water on the floor or
storage shelves.

Changing the light bulb

Warning!
Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse
or the circuit breaker.
Light bulb data: 220-240 V, max. 15 W
To switch off the appliance, set the temperature regulator to position
Unplug the mains plug.
To change the light bulb, undo the screw.
Press the light bulb cover and slide it backwards.
Possible Cause
Appliance is not switched on.
Mains plug is not plugged in or is
loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cold.
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
The appliance is near a heat
source.
Light bulb is defective.
Door seal is not air-tight(possibly
after reversing the door).
Appliance is not level.
The appliance is touching the wall
or other objects.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
This is normal, no error has
occurred.
Water drain hole is blocked.
10
GB
Remedy
Switch on the appliance.
Insert mains plug.
Check fuse, replace if
necessary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature
regulator to a warmer setting
temporarily.
Please look in the "initial Start
Up" section.
Open the door only as long
as necessary.
Turn the temperature
regulation to a colder setting
temporarily.
Please look in the "installation
location" section.
Please look in the "changing
the Light Bulb "section.
Carefully warm the leaking
sections of the door seal with
a hair dryer(on a cool
setting). At the same time
shape the warmed door seal
by hand such that it sits
correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend
the component out of the
way.
The compressor starts after a
period of time.
See the "cleaning and care"
section.
0 .

Publicidad

Tabla de contenido
loading

Tabla de contenido