Intended Use; Operating - ClickTronic 60806 Manual De Instrucciones

3 Intended Use:

It is not allowed to use the device
in other ways than described in chapter
"Description and Function". Use this
device only in dry interior rooms. The symbol
with the house reminds you of that. If you do not
attend to these regulations and notes on safety,
it might causes fatal accidents, injuries and da-
mages to persons and property.
4 Parts Package:
• 1 pc. Full HD Splitter
• 1 pc. power supply 5 V DC
• 1 pc. user's manual
60806:
60807:
5 Connection, Implementing and
Operation:
5.1Connection and Implementing
1. Connect the HDMI
to the input of the Full HD splitter.
2. Connect the HDMI
to the outputs of the Full HD splitter (Output
1/2/3/4 or 1/2/3/4/5/6/7/8).
3. Setting the resolution of the outputs:
Set the output resolution of the source device
first, make sure the resolution can be
displayed on all connected display devices.
For example, if you set the output resolution of the
source device to 1080p, make sure all display de-
vices can display 1080p resolution. If any connected
display device cannot support 1080p resolution, the
display device will show no pictures.
4. Plug the 5 V DC power supply into the Full HD
splitter. When connecting is completed, the
HDTV signal will be distributed to each HDTV.
5. When all connections are set, the output sig-
nal will be displayed at al HD displays.
6. To get a better performance, restart the Full
HD splitter. This way you also make sure,
HDCP is working properly.
12
60806+60807_(HC414+418)-14lng_V1.indd 12-13
cable from the HD source
TM
cables from your displays
TM
Clicktronic®
Sample Figure: The models differ in the number
of outputs.

5.2Operating:

Switch the Full HD splitter on or off by
pressing the POWER switch at the
back of the housing for one time.
Controlling:
• HDMI™ connections require the EDID and
HDCP data between source and output de-
vices for successful communication.
• Make sure your source device supports auto
detection and adjustment of resolution, color
depth and audio format.
• Your splitter comes with 2 detection modes.
• The mode selector switch is located on the
back of the splitter.
• The standard-setting mode is A.
• Ensure that all source and output devices
support the same formats.
Mode A - Automatic detection
(lowest standard first):
A/B
Source device supports automatic detection
and adjustment:
Based to EDID information of all devices, the
source device with the lowest standard is set as
primary device.
Source device does NOT support automatic
detection and adjustment:
Set the output resolution and color depth of the
source device manually to the output device
data with the lowest standard.
Mode B (priority mode):
A/B
Connect the primary output device you want to
communicate with the splitter on port 1.
Source device supports automatic detection
and adjustment:
The output device on port 1 is automatically
selected as primary device and sets up its
settings.
Clicktronic® 13
17.01.2012 12:36:03