Before Using - Sinbo SS 4034 Manual De Instrucciones

SINBO SS 4034 LINT REMOVER
INSTRUCTION MANUAL
IMPORTANT ATTENTION
1. Flat the clothes before using to avoid damaging the clothes.
2. Do not press the appliance hard when using in order to avoiding damages to clothes.
3. Do not use the appliance to the clothes you are wearing, otherwise may cause hurt or
damages to clothes.
4. The appliance complies with: GB4706.1-2005
CHARGING MODE
• Before charging, make sure the appliance shuts off (Pic 1)
• Power: Voltage 230V,frequency 50Hz
• The charging time is 8 hours, please disconnect the plugs from mains after charging,
otherwise it will reduce the duration of the batteries.
• Charging the lint remover at temperature of 5˚C to 35˚C.
• After charging, keep the cord well and prepare for the next use.
• Make sure that the cord be replaced from the manufacturer or original after-service
centre if it is damaged.

BEFORE USING

In order to avoiding accident
• Note the following parts
1. Button, zipper around
2. The ledge of clothes
3. Remove the foreign matter sticking in the
clothes
4. The connect-part or the thread end of the
connect-part
5. The parts where the texture is thin or more
fissile
• Do not take for other use except removing lint.
• Test on inconspicuous part of the clothes
before using.
ENGLISH
1
3
5
- 6 -
2
4