LaserLiner Greenline-Laser 3P Manual De Instrucciones página 13

Use of lithium-ion rechargeable battery
1
Before using the laser for the first time, insert the
battery in the device and fully charge (at least 5
hours). Connect the battery charger to charge
the battery. The LED lights red while the battery
is charging and green when the battery is fully
charged. Recharge the battery as soon as one or
several laser lines switch off. The rechargeable
battery can also be charged when it is not inserted
in the device.
– The battery may only be charged with the battery charger provided
and used only in this laser device. Any other use may cause injury
or fire.
!
– Make sure there are no conductive objects in the vicinity of the
battery contacts. Short-circuiting of these contacts can cause burn
injuries or fire.
– Do not open the rechargeable battery. This could cause short-circuits.
Horizontal and vertical levelling
2
Turn the transport fastener (2) clockwise and release the pendulum lock.
The lasers are now automatically aligned by the pendulum system and the
horizontal laser lights constantly. The lasers can be switched on and off
individually with the H and V buttons. It is now ready for levelling in the
horizontal or vertical plane.
If the device is too far off the horizontal (more than 2°), the lasers will
!
blink. Align the device using the adjustable feet (6) or place on a more
level surface. The round vial (8) is provided as an aid to alignment.
Positioning laser lines
3
The top section of the laser unit can be turned on the plinth to align the
lasers approximately. Precise positioning can then be done with the Vernier
adjustment (3). The adjustable feet (6) allow the device to be positioned on
sloping surfaces.
Greenline-Laser 3P / 5P
GB 13