Charging Base - Mellerware Tidy! Random Manual Del Usuario

CHARGING BASE

11 – Charging base
12 – Charger
13 – Charging contact points
NOTE: Insert 2 AAA batteries before
–
using the remote control for the fi rst
time. Make sure that the positive
and negative poles are located in
the correct direction in the battery
compartment.
If the model of your appliance does
–
not have the accessories described
above, they can also be bought
separately from the Technical
Assistance Service.
IMPORTANT: Cables or other
–
objects on the ground can hinder
the mobility of the robot. Remove
these objects before using the
robot vacuum cleaner.
Use the vacuum cleaner the robot
–
only on short pile carpets.
Furniture less than 8cm can block
the robot. Lift the furniture if you
need to clean this area.
Put a safety barrier on the stairs
–
to prevent it from falling in case
the fall arrest sensors do not work
properly.
Installation
Be sure to remove all packaging
material from inside the appliance.
CHARGING BASE POSITION
Connect the charger to the
–
charging base.
Place the load base fl at and next
–
to the wall.
To receive a good signal, you must
–
leave a radius of 1m to the right
and left and 2 meters forward of
the base.
Connect to the power.
–
EN