Maintenance And Repair; Technical Data - MS Schippers 1509330 Instrucciones Para El Uso

3.2.2. Plug the mains plug into the outlet that has been installed by a qualified electrician. It has to
be equipped with a differential-current switch (FI) with a response current of 30mA. After having
plugged in the milk heater the liquid must not be touched anymore.
3.2.3.Set the desired temperature with the thermostat. (0) corresponds to "off". Then the scale 1-
10 adjusts the temperature from 30°C up to 90°C.
3.2.4. ATTENTION: Only use your milk heater under permanent supervision.
3.2.5. Pay attention that the level of liquid does not drop below the minimum depth when heating
up over a longer period of time. Under no circumstances cover the milk heater nor the container.
3.2.6. When the red control lamp goes out the desired temperature has been reached. Set the
thermostat to the "off" position and unplug the unit from the outlet. Leave the milk heater for about
another minute in the liquid before you remove it.
3.2.7. The heating element will still be hot after it has been removed from the liquid and must not
be touched. Place the milk heater on an incombustible surface. Do not ever place it on
combustible materials (e.g. straw).
3.2.8. After every use the milk heater has to be cleaned. The heating element can be cleaned with
a brush and lukewarm soapy water. For cleaning the handle, please use a soft cloth that has to be
free of any solvents (acetone, petrol, alcohol, etc.).

4. Maintenance and repair

The milk heater is maintenance-free. In case of a malfunction the unit has to be stopped
immediately. In case the milk heater has to be repaired, consult a qualified electrician or send the
unit back to the manufacturer. Even a defective connecting cord must only be replaced by the
manufacturer or a qualified electrician.

5. Technical data


Height: 875 mm

Heating element ø: 165 mm

Weight: 7,45 kg

Immersion depth: 750 mm

Supply: 230 Volt

Output: 3000 Watt

Maximum temperature: 90° C
6