Emerio SEW-122595.2 Manual De Instrucciones página 7

HOW TO THREAD:
Thread should flow from the top right of the bobbin. Spring must be in place before installing the bobbin. (Fig.
5)
1. Pass thread upward through the eyelet of the thread guide 1. From bottom to top.
2. Pass thread over top of tension control between the two silver discs.
3. Pass thread through the eyelet of the thread guide 2, from front to back.
4. Pass thread through the eye of the needle, from right to left. You can use the threader to help you.
ADJUSTING THREAD TENSION:
1. If stitching is too tight, turn tension control slightly to the left.
2. If stitching is too loose, turn tension control slightly to the right.
TO REPLACE A NEW BOBBIN
1. Lossen the bobbin shaft (D) and take off the used bobbin.
2. Slide the new bobbin and the sping into the bobbin shaft. Then connect to the bobbin nut (E).
3. When purchasing replacement bobbins for this appliance, please note it uses a class 15 metal bobbin.
TO INSTALL A NORMAL THREAD SPOOL
1. Lossen the bobbin shaft and take off bobbin.
2. Slide the thread spool into the extension spindle. Do not forget the sping.
3. Connect the extension spindle onto the bobbin nut.
Fig. 7
Fig. 5
- 6 -