Intended Use; Technical Specifications - Roney Power RPG 8-115 Manual De Instrucciones

INTENDED USE

This tool is intended for grinding, cutting and deburring metal and stone materials without the use of water;
with the appropriate accessories the tool can also be used for brushing and sanding

TECHNICAL SPECIFICATIONS

PRODUCT ELEMENTS
1. Spindle
2. Auxiliary handle
3. Safety guard
4. On/off locking switch
5. Switch locking knob
SAFETY
WARNING! Read all instructions. Failure to follow all instructions listed below may result in electric shock,
fire and/or serious injury.
• Only use this tool for dry grinding/cutting
• Only use the flanges which are supplied with this tool
• This tool should not be used by people under the age of 16 years
• Always disconnect plug from power source before making any adjustment or changing any accessory
ACCESSORIES
• Use the original accessories which can be obtained from your dealer
• For mounting/using non-orignial accessories observe the instructions of the manufacturer concerned
• Use only accessories with an allowable speed matching at least the highest no-load speed of the tool
• Do not use damaged, deformed or vibrating grinding/cutting discs
• Handle and store grinding/cutting discs carefully to avoid chipping and cracking
• Protect accessories from impact, shock and grease
• Do not use a grinding/cutting disc that is larger than the maximum recommended size
• Only use grinding/cutting discs with a hole diameter which fits mounting flange (7) without play; never use
reducers or adaptors to fit large-hole grinding/cutting discs
• Never use grinding/cutting discs with a threaded hole, of which the thread is not long enough to accept the
spindle length of the tool
• Never use accessories with a "blind" threaded hole smaller than M14 x 21 mm
OUTDOOR USE
• Connect the tool via a fault current (FI) circuit breaker with a triggering current of 30 mA maximum
• Only use an extension cord which is intended for outdoor use and equipped with a splashproof coupling-
socket
BEFORE USE
• Before using the tool for the first time, it is recommended to receive practical information
• Do not work materials containing asbestos (asbestos is considered carcinogenic)
• Take protective measures when during work dust can develop that is harmful to one's health, combustible
or
explosive (some dusts are considered carcinogenic); wear a dust mask and work with dust/chip extraction
when connectable
• Be careful of hidden electrical wires or gas and water pipes; check the work area, for instance with a metal
detector
• Be careful when cutting grooves, especially in supporting walls (slots in supporting walls are subject to
country- specific regulations; these regulations are to be observed under all circumstances)
• Clamp the workpiece in case it does not remain stationary from its own weight
• Do not clamp the tool in a vice
• Use completely unrolled and safe extension cords with a capacity of 16 Amps (UK 13 Amps)
• Wear protective glasses and gloves, hearing protection and sturdy shoes; when necessary, also wear an
apron
• Always mount auxiliary handle (5) and protective guard (6); never use the tool without them
• Be sure tool is switched off when plugging in
DURING USE
• Always keep the cord away from moving parts of the tool; direct the cord to the rear, away from the tool
6