Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING!: Operating device 07833 must only be used in conjunction with the following range of locks
E
3
And with the following original strikers:
Use in conjunction with other locks and strikers does not guarantee correct functioning and invalidates the CE certification.
1 – Drill the holes and form the slots in the door upright (see fig. 1) to hold the lock (and the supplementary closing points in the
case of multipoint versions), the cylinder hole, and the square pin (this must be a through hole if an external opener is to be
fitted) (see fig. 1). Use the lock and the spacer plates as templates to mark out the lock and operating mechanism fixing holes
prior to drilling.
Fig. 1
2 – If you are fitting a multipoint lock, shorten the front plate at the top to suit the height of the door upright. Check the
direction of the lock and modify it if necessary by means of the screw at the rear.
ISTRUZIONI - INSTRUCTIONS - INSTRUCTIONS - INSTRUCCIONES
Central lock
Code
07643
25
07644/07662
30
07645/07673
35
Multipoint lock
Code
07653
25
07654/07666
30
07655/07667
35
Front flat lock
B
A
07690
07691
07692
07693
07694
07695
PREPARATION AND CHECKS PRIOR TO INSTALLATION
12
17
E
A
40
45
50
E
A
40
45
50
- 7/16 -
Central lock
Code
07640
07641/07660
07642/07661
Multipoint lock
Code
07650
07651/07664
07652/07665
E
6
Front U lock
B
A
S
E
A
25
40
30
45
35
50
E
A
25
40
30
45
35
50
07700
07701
07702
07703
07704
07705
I0328002/03-2018
Publicidad
Tabla de contenido
