Sanitas SZA 50 Instrucciones Para El Uso página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
6. Now slide the charging station onto the secure wall mount from above (
Figure 1
Charging the rechargeable toothbrush
Before using for the first time the built-in rechargeable battery in the easy grip electrical
toothbrush must be charged. Charging takes at least 24 hours. The easy grip electrical
toothbrush is then available for around 60 minutes of operation.
1. Connect the charging station (5) to the mains voltage specified on the type plate.
2. Place the easy grip electrical toothbrush (4) on the charging station (5) such that the
control buttons face forward. The charge indicator (3) lights red as soon as the easy
grip electrical toothbrush is charging. If the charge is very weak at the start of charging,
the charge indicator blinks up to several hours long and then changes to light continu-
ous red. When fully charged, the charge indicator lights green. The inbuilt overcharging
protection means that the battery cannot be overcharged.
3. The easy grip electrical toothbrush always remains fully operational if you leave it in the
charging station for daily use. The inbuilt overcharging protection prevents damage to
the battery.
You obtain the maximum battery capacity if you discharge the battery at least once every 6
months. For this purpose, disconnect the charging station (5) from the mains and discharge
the battery through normal use. Then fully recharge the battery.
6. Using the toothbrush
Brushing teeth
WARNING
Slight bleeding of the gums may occur when used for the first time. Should bleed-
ing of the gums persist for longer than two weeks, consult your dentist.
Note
• Dentists recommend cleaning for 2 minutes.
• It is recommended to replace the brush head every 2-3 months.
• For safety reasons and to protect your teeth and gums, the device automati-
cally switches off after 10 minutes.
CAUTION
• Always switch off the easy grip electrical toothbrush when replacing the brush
head.
1. Clean the brush head with warm water before using for the first time. Push the brush
head onto the easy grip electrical toothbrush. Ensure that the bristles point toward the
control buttons and that the brush head is firmly attached.
Figure 2
11
).
Figure 3
Figure 3

Publicidad

Tabla de contenido
loading

Tabla de contenido