Voltage Detection - General MSV250 Manual Del Usuario

MSV250 -FINAL1A- 032709:Layout 1
Water Pipe
Figure 3
continuously and the LED will light up. To
pinpoint the exact position after the metal has
been located, gradually rotate the sensitivity
control toward the 'OFF' position to reduce the
sensitivity and sweep over the area again.

VOLTAGE DETECTION

Slide the selector switch which is located on the
right side of main body to the "VOLTAGE"
position. Check that there is no source of
electricity in the immediate vicinity then adjust
the sensitivity control in the same way for
metal detection.
Steps for Voltage Scanning
Hold the detector horizontally with the marking
position pointing towards the wall (Figure 4) and
sweep systematically over the required area. If a
source of voltage is detected, the unit will beep
on and off and the red LED will flash. If the
source of the voltage is very close to the
detector, the beep will sound continuously and
the red LED will light up. Pinpointing the exact
position of the voltage source is done by
6
Electrical
Wire
Figure 4
3/27/0