Electrical Connection - Leuze electronic CU405-2M12 Manual Del Usuario

EN

Electrical connection

The data regarding the electrical supply of the RSL 410 applies to the voltage supply
and the switching outputs (see the
chapter 8 "Electrical connection" and chapter 15 "Technical data").
NOTE
 Make sure that the voltage supply is suitable for the RSL 410.
NOTE
Laying cables!
 Lay all connection cables and signal lines within the electrical installation
space or permanently in cable ducts.
 Lay the cables and lines so that they are protected against external damages.
 For further information: see EN ISO 13849-2, Table D.4.
Pin assignment
2
ETH, M12 socket, D-coded
Pin No. Signal
1 TD+
2 TD-
3 RD+
4 RD-
FE GND/shield
Connect the M12 housing/cable shield to the functional earth via the
RSL housing
X1, X2, M12 plug, A-coded
Pin No. X1
Signal
1 +24 V DC
2 OSSDA2
Safe switching output
3 0 V
4 OSSDA1
Safe switching output
FE Connect the M12 housing/cable shield to the functional earth via the
RSL housing
12
original operating instructions
X2
Signal
Not used
Not used
Not used
MELD
Signal output
for the RSL 410,