Publicidad
Step 17
IMPORTANT: THIS UNIT MUST BE SECURE TO THE WALL TO HELP PREVENT TIPOVER. FOLLOW
THESE INSTRUCTIONS TO INSTALL THE ANTI‐TIPPING SAFETY BRACKET PROVIDED WITH THIS
PRODUCT.
OPTION 1: Attachment into a wall
stud (preferred method)
Using a stud finder, locate a stud in the
wall. Place your unit against the wall,
with the safety bracket aligned in this
location. To make driving the screw
easier, you can drill a 1/8" diameter
pilot hole (3mm) through the safety
bracket into the stud. Drive the screw
through the safety bracket into the
wall stud. Tighten the screw that was
not fully tightened in step 7.
OPTION 2: Attachment into drywall
Locate your unit where desired against
a wall and mark the wall through the
safety bracket, then move your unit
aside. Drill a 3/16" diameter hole
(5mm) into the wallboard. Tap the wall
anchor into the hole until it is flush.
Move your unit into location and
fasten the wall bracket to the wall
anchor with the screw. Tighten the
screw that was not fully tightened in
step 7.
littleseedskids.com
13c
13d
24
For Masonry, Concrete, or other
wall materials:
Consult your local hardware store
for appropriate anchors to securely
attach the safety bracket.
hole
13d
13c
stud
wallboard
Publicidad
