Publicidad
1)
Unscrew the connector (24) from the connecting element (22) of the upper arm of the shower (19). Loosen the screw (23) using a hexagon
key (C).
2)
Insert the connector pipes with the o-rings of the upper arm of the shower (19) into the lower pipe of the shower (15). Set the parts (19) and
(15) in the correct position and fit the screws (18) using a hexagon key (B). Set the fixing element (22) in the correct position and fit the
screw (23) using a hexagon key (C).
3)
Screw the connector (24) onto the screw (23) of the connecting element (22). Slide the assembly
holder (27) onto the connector (24). Slide the lower end of the arm of the shower (15) onto the
connector pipe with the o-ring (7) of the shower body.
4)
Set the installation holder (27) correctly on the wall (see fig. 3.4) and mark the 3 points for installing
the wall plugs. Slide out the complete shower arm from the connector pipe (7) of the
shower body and place it on the side, slide the installation holder (27) from the connector (24).
5)
Drill three Ø1/4" (Ø6mm) holes (see fig. 3.4), insert wall plugs (29) to the holes and attach the
installation holder (27) to the wall (30).
6)
Put the rosette ring (25) with gasket (26) on the connector (24). Slide the lower end of the arm of
the shower (15) onto the connector pipe with o-ring (7) of the shower body and slide the connector
(24) into the installation holder (27) Set the complete shower arm in the correct position and screw
in the screws (18) and (28) using a hexagon key (B). Slide the rosette ring (25) with its gasket (26)
onto
the
installation
7)
Screw the shower header nut (32) onto the connector (21) in the upper shower (19). Pay
attention to the correct position of the flat gasket (31), flow regulator (42), metal washer (44) in
the header (32).
IOG 2861.00
LOWER AND UPPER ARM ASSEMBLY AND THE SHOWER HEAD
holder
(27).
Slide
the
3.2
rosette
ring
to
the
finishing
5
SHOWER ASSEMBLY
CONJUNTO DE DUCHA
wall.
3.3
2.1
3.1
3.4
Rev. 2 July 2016
Publicidad
