Publicidad
1)
Screw the clamp nut of the lower shower pipe section (11A) onto the threaded connector pipe of the shower body (1A). Check if the flat
washer (10) is positioned correctly. Position the lower section (11A) according to fig. 3.1. Tighten the nut with the correct size wrench fitted
with protective pads to avoid damage to the finishing of the cap.
Slide the upper shower pipe section (17A) onto the lower shower pipe section (11A) connector (14). Do this carefully to avoid damage to the
2)
o-rings. Position the upper section (17A) correctly.
3)
Secure the installation holder (24) and screw the clamp nut (20) onto the connector of the holder. Place the installation holder (24) in the
right position on the finished wall so the screw holes are both aligned horizontally. Outline the contours of the holder (24) on the wall, as well
as the screw holes.
4)
Hold the installation holder (24) and unscrew the clamp nut (20). Then remove the upper section of the shower (17A) from the connector
(14). Put it somewhere safe to avoid damage.
Drill the holes in the two places you marked with a pencil Ø1/4" (Ø6mm). Check if the distance between the holes conforms to fig. 3.2. Insert
5)
the wall plugs (25) into the holes. Fix the installation holder (24) to the walls with fixing screws (26).
6)
Put the rosette ring (22) and the washer (23) onto the support (19).
Mount the upper section of the shower (17A) back onto the connector (14). Be careful not to damage the o-rings. Position the upper section
7)
of the shower (17A) correctly.
Screw the clamp nut (20) onto the installation holder (24). Push the rosette ring (22) with the washer (23) carefully onto the surface of the
8)
wall.
9)
Check if the shower arm (31) is set inside the support (19) at a minimum of 3-15/16" (100mm) – see fig. 3.4. To do this, loosen the locking
nut (29) and retract the shower arm (31) from the support (19). Measure at least 3-15/16" (100mm)from the end of the arm, then set it
(31) into the support (19) at the distance required. Then tighten the locking screw (29).
Screw the nut of the shower head (34) onto the connector (32) of the shower arm (31). Check if the flat washer, flow regulator (42), metal
10)
washer (44) is positioned correctly (32) in the nut of the head (34).
IOG 2335.007
LOWER AND UPPER ARM ASSEMBLY AND THE SHOWER HEAD
3.1
3.2
5
SHOWER ASSEMBLY
CONJUNTO DE DUCHA
Rev. 1 May 2017
2.1
3.3
Publicidad
