Troy-Bilt TB57HB Manual Del Operador página 3

ASSEMBLY INSTRUCTIONS
Removing the Battery
1. Press the latch button on the battery down and hold (Fig. 5).
2. Grasp the handle fi rmly and pull the battery out of the handle cavity.
NOTE: The battery fi ts into the handle cavity snugly in order to prevent accidental dislodging. It
may require a strong pull to remove it.
CAUTION:
When the battery is not installed in the unit, keep it away from paper
clips, coins, keys, nails, screws or other metal objects that could make a connection
from one terminal to another. Shorting the battery terminals together may cause sparks,
burns or a fi re.
IMPORTANT! The battery is equipped with an internal circuit breaker that will automatically shut off
power to the unit if the battery is overloaded during heavy use. Once cooled, the battery will
reset itself. Follow these steps if an overload occurs:
1. Set the switch to the OFF position and then restart the unit. Refer to Starting and Stopping
Instructions.
2. The battery may need to be removed for approximately 1 minute, allowed to cool and then
reinstalled.
WALL-MOUNTABLE
The battery charger features a key-hole hanging feature for convenient storage. Screws should be
installed so that the center distance is 3 5/32" (8 cm). Use proper wall fasteners to accommodate the
combined weight of the battery charger and the battery (approximately 3.5 lb [1.6 kg])
CORD WRAP
The battery charger is equipped with a cord wrap that is located at the rear of the unit (Fig. 2). Use
this feature to minimize workspace clutter and hazards.
STARTING AND STOPPING INSTRUCTIONS
STARTING THE MOTOR
The blower is equipped with a two-speed switch.
1. Fit the battery into the handle cavity (Fig. 5). Refer
to Installing the Battery.
2. Press the switch to either the HIGH or LOW position
(Fig. 6).
STOPPING THE MOTOR
1. Press the switch to the OFF position (Fig. 6).
OPERATING INSTRUCTIONS
WARNING:
Do not allow familiarity with this unit to promote carelessness.
Remember that a careless fraction of a second is enough to infl ict serious injury.
WARNING:
If any parts are damaged or missing, do not operate the unit until the
parts are replaced. Failure to heed this warning could result in serious personal injury.
WARNING:
Always wear appropriate eye and ear protection when operating this
unit. Wear safety goggles, or safety glasses with side shields, that are marked as
meeting ANSI Z87.1-1989 standards. Failure to do so could result in serious eye injury
caused by thrown objects. If the operation is dusty, wear a facemask or dust mask.
WARNING:
Wear non-slip gloves for maximum grip and protection. Refer to the
Safety Information section for appropriate safety equipment.
PROPER GRIP ON HANDLE
• Always maintain a proper grip on the handle whenever the motor is running. The fi ngers should
encircle the handle and the thumb should wrap under the handle.
PROPER STANCE
• Balance body weight securely, with both feet on solid ground.
WORK AREA PRECAUTIONS
WARNING:
Do not expose the unit to rain. Do not use the unit in damp or wet
locations or conditions.
• Keep everyone – helpers, bystanders, children and animals – at least 50 feet (15 m) away from the
work area. If anyone enters the work area, stop the unit!
• Only operate the unit when visibility and light are adequate to see clearly.
• Use rakes and brooms to loosen debris before operating the unit.
• Remove stones, nails, glass and wire from the area before operating the unit.
• Take care when operating the unit near windows and vehicles.
• To reduce noise levels, operate the unit at the lowest speed needed to do the job.
• Only operate the unit during reasonable hours. Comply with times listed in local ordinances.
BASIC OPERATING PROCEDURES
1. Start the motor. Refer to Starting and Stopping
Instructions.
2. Hold the blower with the nozzle several inches
above the fl oor or ground (Fig. 7).
3. Sweep the nozzle from side to side while slowly
advancing, directing the accumulated pile of debris
ahead of the operator.
4. Dispose of debris appropriately.
MAINTENANCE AND REPAIR INSTRUCTIONS
CLEARING A BLOCKED BLOWER TUBE OR NOZZLE
WARNING:
Before inspecting, cleaning or servicing the unit, stop the motor, wait for
all moving parts to stop and remove the battery. Failure to follow these instructions can
result in serious personal injury or property damage.
1. Stop the motor and remove the battery from the unit. Refer to Removing the Battery in the
Assembly Instructions section.
2. Disconnect the blower tube from the blower and the nozzle from the blower tube.
3. Use a fi rm-bristled, non-wire, brush to clear the blower tube, nozzle and blower opening of all debris.
4. Once clear of obstructions, re-assemble the unit. Refer to Assembly Instructions.
NOTE: If it is necessary to replace damaged or missing parts, use only manufacturer suggested
replacement parts. The use of any other parts may create a hazard or cause product damage
and will VOID the warranty.
BATTERY CHARGER MAINTENANCE
• To ensure safety and reliability, all repairs should be performed by a qualifi ed service technician.
• Keep the charger clean and clear of debris. Do not allow foreign material into the recessed cavity
or on the contacts.
• Always unplug the charger when not in use.
• Check that the charger contacts have not been shorted by debris or foreign material.
OFF
HIGH
Two-speed
LOW
Switch
Fig. 6
Fig. 7
CLEANING AND STORAGE
WARNING:
Do not let brake fl uids, gasoline, petroleum-based products, penetrating
oils, etc., come in contact with plastic parts. These chemicals may damage, weaken
and destroy plastic, which may result in serious personal injury.
WARNING:
DO NOT use a damp cloth or detergent on the battery or battery
charger. Wipe the outside with a dry, soft cloth.
CLEANING INSTRUCTIONS
• Remove the battery from the unit.
• Use a fi rm-bristled, non-wire, brush to remove debris from the air openings, blower tube and nozzle.
• Wipe the unit down with a damp cloth. Do not douse the unit with water. Do not use solvents or
strong detergents.
STORAGE INSTRUCTIONS
• Follow the Cleaning Instructions listed above.
• Store the unit in a dry, high and/or locked location, out of the reach of children and other
unauthorized persons.
• Give the battery a full charge before placing it in storage.
• Keep the charger and battery pack in an area that is between 65 and 75˚ F (18 and 24˚ C). When it
is fully charged, the battery can be stored in temperatures as low as 23 °F (–5 °C) for a period of
up to two weeks before it requires recharging.
ENVIRONMENTALLY SAFE BATTERY DISPOSAL
The following toxic and corrosive materials are in the batteries used in this unit battery pack:
LITHIUM-ION, a toxic material.
WARNING:
All toxic materials must be disposed of in a specifi ed manner to prevent
contamination of the environment. Before disposing of damaged or worn out lithium-
ion battery packs, contact your local waste disposal agency for information and
specifi c instructions. Take batteries to a local recycling and or disposal center, certifi ed
for lithium-ion battery disposal.
WARNING:
If the battery cracks or breaks, with or without leaks, do not
recharge it and do not use. Dispose of it and replace with a new battery. DO NOT
ATTEMPT TO REPAIR IT!
To avoid injury and risk of fi re, explosion, or electric shock, and to avoid damage to the environment:
• DO NOT attempt to remove or destroy any of the battery components.
• DO NOT attempt to open the battery.
• DO NOT place these batteries in your regular household trash.
• DO NOT incinerate.
• DO NOT place them where they will become part of any waste landfi ll or municipal solid waste stream.
• Cover the battery's terminals with heavy-duty adhesive tape.
• If a leak develops, the released electrolytes are corrosive and toxic. DO NOT get the solution in
the eyes or on skin, and do not swallow it.
• Dispose of the battery pack in accordance with local state and federal regulations.
TROUBLESHOOTING
CAUSE
THE BATTERY WILL NOT CHARGE
There is no power to the charger or battery
The battery has failed
THE MOTOR OPERATES SLOWLY OR WILL NOT OPERATE
The battery lacks suffi cient charge
THE UNIT WILL NOT BLOW
The impeller (fan) is damaged
The nozzle, blower tube or blower opening is
blocked
NOTE: For maintenance beyond the minor adjustments listed above, or for replacement parts, please
call the Customer Support Department at 1-800-828-5500 (U.S.) or 1-800-668-1238 (Canada).
SPECIFICATIONS*
MOTOR
Type ............................................................................................................... Cordless, Battery-powered
Motor ................................................................................................................................................. 20 V
Motor Speed ........................................................................................................................... 13000 rpm
Air Volume ................................................................................................................ 75 CFM & 110 CFM
Air Speed ...............................................................................................85 & 125 mph (135 & 200 km/h)
Weight (with Battery) ......................................................................................................6 lb 4 oz (2.9 kg)
BATTERY / BATTERY CHARGER
Battery ................................................................................................................................... 20V Lithium
Charge Time .............................................................................................................................. 4.5 hours
Battery Weight .............................................................................................................3.24 lbs. (1.47 kg)
Optimum Charging Temperature .....................................................................32° to 104° F (0° to 40° C)
Battery Charger Input.............................................................................................. 120 V 60 Hz AC only
Battery Charger Output Maximum .................................................................................................... 21 V
Battery Charger Weight ................................................................................................1.65 lbs. (0.75 kg)
* All specifi cations are based on the latest product information available at the time of printing. We
reserve the right to make changes at any time without notice.
SOLUTION
Check the charger and charging station
Replace the battery
Charge the battery
Refer to Service Information
Clear the blockage. Refer to Clearing a
Blocked Blower Tube or Nozzle in the
Maintenance and Repair Instructions section.
3