Safety Instructions - Behringer TM300 Manual De Instrucciones

2
TUBE AMP MODELER TM300
Use the AMP switch to select one of 3 great classic tube amps.
(7)
You will recognize these classic amp tones as soon as you hear
them. For crystal-clear, transparent sounds with dynamic bass
select TWEED. For aggressive mids and incredible sustain select
BRIT(ISH). Rounder and more evened-out (yet still sophisticated)
sounds can be dialed up if you select CALIF(ORNIAN); it's perfect
for leads.
The ON/BATT LED illuminates when the effect is activated. It also
(8)
serves as a battery level indicator.
Use the footswitch to activate/deactivate the effect.
(9)
Use this ¼" TS IN connector to plug in the instrument cable.
(10)
The ¼" TS OUT connector sends the signal to your amp.
(11)
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover.
To install or replace the 9 V battery (not included), press the hinges with
a ballpoint pen and remove the pedal cover. Be careful not to scratch
the unit.
◊ ◊
The TM300 has no on/off switch. As soon as you insert
the plug into the in connector, the TM300 is on. When not
in use, remove the plug from the in connector. This extends
the life of the battery.
The SERIAL NUMBER is located on the bottom.

2. Safety Instructions

Do not use near water, or install near heat sources. Use only authorized
attachments/accessories. Do not service product yourself. Contact our
qualified servicing personnel for servicing or repairs, especially when
power supply cord or plug is damaged.
3. Limited Warranty
For the applicable warranty terms and conditions and additional
information regarding Music Tribe's Limited Warranty, please see
complete details online at musictribe.com/warranty.